Install the PA‐220 Firewall in a 19" Equipment Rack
Install the PA‐220 Firewall in a 19" Equipment Rack
The PA‐220 firewall one‐unit (1U) rack tray kit (PAN‐PA‐220‐RACKTRAY) enables you to install one or two
PA‐220 firewalls in a 19" equipment rack. The installation hardware (screws and brackets) for the left side
of the tray are contained in bags and the installation hardware for the right side of the tray are pre‐installed.
This enables you to store the right side hardware in the tray (for future use) if you are installing only one
firewall.
To ease installation, first install the firewall(s) in the rack tray and then install the assembled rack tray
into the equipment rack.
Install the PA‐220 Firewall in a 19" Equipment Rack
Step 1
Attach one rack tray bracket to each side of the firewall using two 4‐40 x 1/4" screws for each bracket. The
brackets are labeled left and right as shown in the illustration.
Step 2
Attach the power adapter bracket to the back of the firewall using two 4‐40 x 1/4" screws.
18 • PA‐220 Next‐Gen Firewall Hardware Reference
Copyright © 2007-2017 Palo Alto Networks
Install the PA‐220 Firewall
© Palo Alto Networks, Inc.