Part List For Installation; Installing The Unit (In-Dash Mounting); When Installing Without The Mounting Sleeve; How To Remove The Unit - JVC KW-R930BT Instruction Manual

INSTALLATION/CONNECTION

Part list for installation

(A) Trim plate (B) Mounting sleeve
(C) Wiring harness (D) Extraction key
(E) Flat head screw (F) Round head screw
(M5 × 8 mm)
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 33)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the terminal of the car battery.
5 Press to turn on the power.
6 Reset the unit. ( 3)
32
ENGLISH

Installing the unit (in-dash mounting)

(M5 × 8 mm)
When installing without the mounting
sleeve
1 Remove the mounting sleeve and trim plate from the
2 Align the holes in the unit (on both sides) with the
damage the unit.
Do the required wiring. ( 33)
Dashboard of your car
unit.
vehicle mounting bracket and secure the unit with
screws (supplied).
Use only the specified screws. Using wrong screws might
Bend the appropriate tabs to hold
the mounting sleeve firmly in place.

How to remove the unit

1 Fit the catch pin on the extraction keys
into the holes on both sides of the trim
plate, then pull it out.
2 Insert the extraction keys deeply into the
slots on each side, then follow the arrows
as shown below.