Advertisement
To remove the face plate of the teleCARE switch modules a screw-
driver with a point of approximately 6mm wide is to be used.
6mm
2000-04-19 / Ver. A
teleCARE Switch Module
Dismantling Instructions
Gently push and turn the screw driver until the
faceplate releases from the backplate.
1
2
Insert the point of the screwdriver into the
groove at the side of the switch module,
between the face plate and the backplate
(or surface mounting frame) at about
10mm from one of the top corners.
3
Specifications are subject to change without notice
Advertisement
