Table of Contents
Advertisement
4.6 Video connection
Video cables and connectors are required to connect the analog
video connection to a suitable display.
Note: The video signal is analog only and is not available
over ethernet.
Video cables
If you require video cables or connectors other than those
supplied with the product please contact your local authorized
Raymarine dealer.
Raymarine recommends the use of a BNC terminated RG59
75ohm (or better) coaxial cable.
Cables and connections
4.7 PoE connection
A PoE injector is required when connecting the thermal camera
to a network switch or a multifunction display that does not
support PoE. An additional PoE injector is required when
connecting a JCU.
The PoE injector requires a 12 V / 24 V dc power supply.
1
2
1
1
12 V / 24 V dc power supply connection to PoE injector. (Power
cable NOT supplied; refer to
cables.)
2
SeaTalk
hs
connection (to network switch or multifunction
display).
3
PoE Injector.
4
Ethernet connection (to thermal camera or JCU).
PoE power connection
The PoE injector requires a dedicated power cable for direct
connection to a 12 V / 24 V power supply.
The unit is intended for use on dc "negative" or "floating" ground
power systems.
Raymarine recommends that all power connections are made
via a distribution panel. All equipment must be either:
• powered from a circuit breaker or switch, with 5A circuit
protection, or
• powered from a 5A slow blow in-line fuse connected to the
RED positive wire of the power cable.
The unit does not have a power switch. The unit is powered
when the power cable is connected to the vessel's power supply.
Note: The unit should be mounted so that the power cable
can be easily removed if necessary. If the unit is placed in a
difficult to reach location, Raymarine recommends installing
an on / off switch on the power connection at a point that is
easily accessible.
Recommended power cable sizes
Cable length
Feet
Metres
10
3
15
4.6
20
6
25
7.6
30
9
Note:
• Cable length is the distance between the power source
and the unit.
• These wire sizes give a total drop of about 0.5 V between
the power source and the unit, achieving a minimum voltage
at the unit of 10.5 V with a fully flat battery at 11 V.
D12849-1
PoE power connection
for suitable
Wire size
mm
2
AWG
14
2.1
14
2.1
12
3.3
12
3.3
10
5.3
Hide quick links:
Advertisement
Chapters
Table of Contents
