Table of Contents
Advertisement
Preparations for Installation
C) Air source
1. Supply the compressive air to the A part shown on the figure.
2. After it, set the air pressure to 0.5 MPa by the regulator.
3. Supply the air cleaned by the air dryer.
• The range of air pressure is between 0.49 MPa and 0.78 MPa.
(The size of the inlet for connecting the hose is 3/8.)
• Adjust the supply air to more than 30 l per minute.
1F4C-AB00
Page 1-4
Pressure Switch
Valve
Outlet of air
To each device
Drain tube
Primary air
Regulator
Primary air supply side
1F4C-827E
Air tube (5m)
1F4C-E-IMA01-A01-00
Advertisement
Table of Contents
