Table of Contents
Advertisement
COLLISION ALERT SYSTEMS
Installation Instructions
Before you Start
Prior to installing the WorkSight PreView Object Detection System take time
to familiarize yourself with the installation instructions, theory of operation, and
system components. Check the contents of the shipping package and verify the
following items are included:
Antenna Sensor (1)
Display Unit (1)
Interconnect Cable (1)
User Manual/Operating Instructions and drill template
Sensor Stainless Steel Mounting Hardware
1-1/4" x 10-24 Bolts, Hex Locking Nuts, and Washers (4)
Display Hardware Kit
Mounting Bracket (1)
Mounting Hardware (1)
Sensor / Antenna Location
The WorkSight PreView sensor mounting location is integral to proper system
operation. Ideally the sensor should be mounted on the rear center of the vehicle
at roughly 36" (1M) +/- 12" (0.3M) above the ground. The sensor face should be
perpendicular to the ground with the "PreView" graphic in normal position. Select
a location that will provide some protection from impact and debris while allowing
an unobstructed view of the target hazard area.
Important!
Before the WorkSight PreView system is permanently installed to the vehicle,
verify that the selected sensor mounting location provides a clear detection zone.
Temporarily attach the sensor in the proposed mounting location, apply power to
the system, and verify that nothing is being detected.
Sensor / Antenna Mounting
1. Select the appropriate sensor mounting location.
2. The correct mounting configuration is with the sensor's text in normal reading
position.
3. Using the drill template, scribe position marks through the holes. Drill 1/4"
(6mm) holes centered at the marks.
4. A 1-1/2" diameter clearance hole is required for the sensor connector and
mating cable connector.
5. Secure the sensor to the vehicle with the four supplied 10-24 UNC button
head screws, washers and nuts or equivalent. Apply a maximum torque of 22
inch pounds when securing the sensor.
www.aps-supply.com
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
F: 1 619 263 6814
APS: Singapore
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS-SUPPLY.COM
Colombia
Chile
Perú
Brasil
Advertisement
Table of Contents
