Train The Device & Perform A Range Test - Hayward AquaConnect AQ-CO-HOMENET Troubleshooting Manual Residential

How To: Train the AquaConnect Device
Use the following steps to train the ACHN to the control system. Make sure both
units are powered up when conducting this step.
Step 2 Step 3
Step 1
Press the "+" button to initiate the
Press the Menu button on the ProLogic Training will be complete when the
controller reports "Teach Wireless
system until the Settings Menu appears, sequence on the controller and hold
Successful" If unsuccessful, reposition
then press the left arrow button until down the teach button on the Aqua
"Teach Wireless: + to start" appears.
Connect Home Network device. and repeat the training process.
NOTE: If training the wireless device fails verify that the antenna is generation 2 (AQL2-BASE-RF). A
GLX-RF-EXTEND is available if the antenna needs to be moved closer to the Aqua Connect.
8