Table of Contents
Advertisement
installation
installation
location
When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between 10°C and 43°C. Avoid
locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight
as it may increase the electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor
installation. Do not drape the unit with any covering.
levelling the unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the doors and magnetic seal alignments
will not be covered properly.
free space requirements
When installing the unit, ensure that 25 mm of
free space is left at both sides, 50 mm at the
rear of the unit and 25 mm at the top of the unit.
The door can be opened to the right or the left,
depending on which best suits the location.
Please ensure there is more than twice the width
and depth distance space of the unit to fully open
the door to a maximum angle of 160°.
installing the door handle
Remove the screw hole plugs. Place the door handle in place and screw tightly. Cover the screw
holes with the door handle screw covers. Button the buckle between the handle and cover, then
snap to close the cover from the inside until a 'pop' sound is heard.
This is an easy-to-open door handle. No hard pull is required, instead just twist the handle gently
and the door can be pulled open easily.
6
Max. 160°
X mm
Y mm
Hide quick links:
Advertisement
Table of Contents
