Table of Contents
Advertisement
installation
3. Remove the hole cover above the levelling
foot of both units. Place a connecting board
and screw tightly. Covers the screws with a
screw cover.
4. Insert a connecting strip in the gap between
the units.
cleaning before use
Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water
using a sponge or cloth. Wipe completely dry before replacing the drawers. Clean the exterior of
the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time to
settle.
before using your unit
Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is working
properly and to allow it time to fall to the correct temperature. Your unit should not be overfilled.
12
3
6
4
7
Hide quick links:
Advertisement
Table of Contents
