Contents Of The Retail Package - Cardo Systems BTA II User Manual

Contents of the Retail package:

• BTA II
• Travel charger
• Pop-Port
connector for Nokia phones
TM
• Velcro pad
• This Quick Start Guide
NOTE: Quick Start Guides in other
languages can be downloaded from
our website.
• Stylus for SET pinhole
• Warranty and Registration card
• Double sided scotch
Pop-Port connector for
Nokia phones
Double sided
scotch tyape
Double sided
scotch tyape
® tape
Velcro pad
Stylus for SET
pinhole
Stylus for SET
pinhole
Getting Started with the Cardo BTA II
1. Charging your adapter
NOTE: You must fully charge the BTA II prior to
initial use!
1. Connect the enclosed AC Adapter to an electrical outlet,
and the cable of the AC Adapter into the charging port of
the BTA II. Charging begins when the red light (LED) turns
on.
2. Once charging is complete, the red LED will shut off.
Allow for no less than 3 hours for to completea a full charge
before initial use of the BTA II.
NOTE: When the BTA II battery is low, the red LED will start
flashing every 3 seconds.
2. Pairing your adapter
Since you are using your BTA II for the first time, you must pair
it to with your Bluetooth headset to make it work. If your BTA II
is part of a Combo retail box along with a Cardo headset, then
you can skip this section, since the headset and BTA II are
already factory paired.
TypicallyNormally you should only once have to perform
pairing between any particular headset and the BTA II.
Thereafter the devices remain paired until you cancel the
existing pairing or assign a new device to the BTA II.
1. Turn on the BTA II by pressing and holding the On/Off
button for 3 seconds, until you see 3 rapid blue flashes of
the LEDs.
2. Follow the instructions in the headset's manual to put the
headset into Pairing mode. (If you are using the Cardo
scala-500 headset, this is done by pressing in and holding
the headset's MFW until the red and blue LEDs begin
alternating rapidly.)
3. Press and hold the SET button of the BTA II for 5 seconds
by inserting the enclosed Stylus gently into the BTA's
pinhole marked SET. When the LEDs begin rapidly flashing
rapidly red and blue, you may release the set button. The
BTA II is now in pairing mode.