Page 1
7. Attaching a Rechargeable Battery Pack 7.1. Recharging a Rechargeable Battery Pack 8. Syncing the Controller 9. Adjusting the Level of Brightness 10. Entering and Exiting the TurboFire EVO Menu 11. Activating Features 12. Pre-installed Features 12.1. Sniper 12.1.1. Configuring Sniper 12.2.
Page 2
In addition to its unique programmability, TurboFire® EVO™ features an integrated headset The TurboFire EVO controller has been designed to be as ergonomic as possible but as with any gaming peripheral you are advised to take regular breaks during your gaming session port for Xbox®...
Re-attach the battery compartment to the controller ensuring that it latches correctly. Important Information The TurboFire EVO does not support the usage of rechargeable AA batteries. For advice on the usage of a rechargeable battery pack, please refer to the next section.
In order to attach a rechargeable battery pack, please follow these steps: Step 1: Before you can use the TurboFire EVO for the first time you need to sync it with your Xbox 360. Whilst pressing and holding the Battery Compartment Button remove the battery To do this, please follow these steps: compartment from the rear of the controller.
Each of the pre-installed features is easily identifiable by the following feature images: Each time you wish to access the TurboFire EVO Menu you need to short tap the Home button on the TurboFire EVO controller. Access the usual Xbox guides when pressing and holding the...
Right Analogue After entering the TurboFire EVO Menu as detailed under section ‘10’, using the A button select Stick Direction Buttons the Sniper feature image to enter the Sniper configuration screen.
The Rapid Fire can be set to operate at different speeds and can be assigned to wide range of buttons. After entering the TurboFire EVO Menu as detailed under section ‘10’, using the A button select the Rapid Fire image to enter the Rapid Fire configuration screen. If you would to return to the TurboFire EVO Menu at any time press the Back button.
Page 8
In order to assign Rapid Fire to the Start button and Back button without exiting the Rapid Fire 12.4. Low Recoil configuration screen. You need to press and hold the F1 or F2 button before pressing the Start button and Back button. The Low Recoil feature allows you to set the level of rumble which you feel during gaming.
EVO Customizer. • Consult the dealer or an experienced radio/TV technician for help. This fantastic feature gives you the ultimate freedom to customize the TurboFire EVO for how you want to play and best of all it is completely free.
This device complies with Part 15 of the FCC rules. 17. Technical Support and Customer Service Operation is subject to the following two conditions: Before contacting Datel’s customer service department, please ensure that you have read through and understood the information in this manual. ...
Need help?
Do you have a question about the TurboFire EVO and is the answer not in the manual?
Questions and answers