Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Symetrix ARC-K1
Summary of Contents for Symetrix ARC-K1
- Page 1 Modular ARCs Quick Start Guide Modular ARCs (K1, SW4, SWK, MIC, XLR, EXK, EX4)
- Page 2 Safety Quick Start Guide 6408 216th Street SW Mountlake Terrace, WA 98043 USA +1.425.778.7728 +1.425.778.7727 | www.SymetrixAudio.com...
-
Page 3: Getting Help
User Serviceable Parts: There are no specified by the manufacturer, user serviceable parts inside this Symetrix If you have questions beyond the scope or sold with the apparatus. product. In case of failure, customers of the help module, contact our Customer When a cart is used, use inside the U.S. - Page 4 DO NOT plug the ARC connectors on Symetrix products into any RJ-45 connector labeled “SYMLINK” , “ETHERNET” or “COBRANET” The “ARC” RJ-45 connectors on Symetrix products can carry anywhere from 6 to 24 VDC which can damage SymLink, Ethernet and CobraNet circuitry.
-
Page 5: Hardware Overview
Upper and lower parameter illuminate to indicate which of the two limits help contain the range of adjustment. The ARC-K1 is available controls is active. All control splash-resistant and mounts into a single gang electrical box assignments, including... - Page 6 Upper and lower parameter more. In addition to the programming modes supported limits help contain the range of adjustment. The ARC-SWK by the ARC-K1 and ARC-SW4, the ARC-SWK integrates is splash-resistant and mounts into a single gang electrical directly with the BGM Room Combiner modules in SymNet...
- Page 7 ARC-SW4’s four are handled by the software included with Symetrix DSP momentary pushbutton hardware. Power, control, and a single channel of ARC switches that provide the Audio (for the onboard mic) are connected via RJ-45 inputs client with simple control or screw-type barrier strips.
- Page 8 ARC Audio line to one or more ARC devices over standard CAT5 cable. These ports may be used to chain multiple ARCs or to home run back to any Symetrix rack mount device with an ARC port. J13: ARC-Audio J12: RS-485 and Power...
-
Page 9: Hardware Setup
Hardware Setup Modular ARCs J3: Modular ARC J2: Modular ARC Expansion Expansion Bus Each RS-485 address (each brain Connects to the Modular ARC expansion devices board) can be daisy-chained to brain board or daisy-chain from this connection. up to four EX4s, whose Board expansion board IDs will range from zero to three. J4: Board ID 1 with the next A table showing which jumpers... - Page 10 Hardware Setup Quick Start Guide Each RS-485 address (each brain board) can have one MIC or XLR. There is no Board ID to set on the J1: Modular ARC J2: Electret Mic Connect/ MIC, however some wiring and Expansion Bus Enable jumpers must be properly placed. Connects to the Electret capsule wires The diagram below specifies the brain board or to pin 1 (+) and pin 2 (-).
- Page 11 Not used for line or Not used for line or (mic gain and phantom power mic level XLR I/O. mic level XLR I/O. supplied by Symetrix rack mount XLR wires directly device). Due to the nature of to J13 on the brain sending low level audio signals board.
-
Page 12: Logic Input
Hardware Setup Quick Start Guide Logic Input J5 on the Modular ARC provides an extra logic input which can system. Pin 1 is the active input, Pin 2 is ground. A typical wiring be wired to any simple closure by the installer. This logic input is is shown below. - Page 13 ARCs arranged in one or more chains over standard CAT5 cable. Most unsubstantiated information regarding these third party products, Symetrix products with an ARC port can power from two (2) to ten (10) it is the policy of Symetrix, Inc. to neither endorse, recommend nor ARCs.
- Page 14 This function may be inverted or apply. Avoid running parallel to other power lines or near any other selectively enabled/disabled from the host Symetrix device’s. Refer to sources of EMI or RFI. Most CAT5 is unshielded and is susceptible to the device’s Help for more information.
-
Page 15: Warranty And Service
We won’t the product within the specified warranty period. return the unit in anything but Symetrix packaging for which we will have Symetrix does not authorize any third party, including any dealer or to charge you. - Page 16 Modular ARCs Quick Start Guide © 2009 Symetrix, Inc. All rights reserved. Printed in the United States of America. The information in this document is subject to change without notice. Symetrix, Inc. shall not be liable for technical or editorial errors or omissions contained herein; nor is it liable for incidental or consequential damages resulting from the furnishing, performance, or use of this material. Mention of third-party products is for informational purposes only and constitutes neither an endorsement nor a recommendation.
Need help?
Do you have a question about the ARC-K1 and is the answer not in the manual?
Questions and answers