Advertisement
How to install this unit with plug-connected wire:
1. Drill 2 holes of 6mm diameter according to the dimensions shown in picture 2, then
insert toggle into the holes and fix hanger to top hole.
2. Fix front and back cover on wall with the screw, then insert toggle into screw hole.
3. Connect with general power and move power switch to "ON" position.
How to install this unit without plug-connected wire:
1. Follow first step of the method above.
2. Loosen the screws as in picture 3 and picture 4 to remove front cover and attach to
plug-connected wire from terminal.
3. Open the wire entry hole; pull the reserved wire through that hole.
4. Fix the reserved wire on terminal, note direction of N, L wire, replace terminal to its
original position.
5. Fix the front and back cover on wall with the screws.
6. Turn on general power and move power switch to "ON" position.
How to install in drawer:
1. Drill two holes of 4mm diameter. The distance between the two holes is 80mm.
2. Fix the base of this unit on bottom board of drawer with the screws as in picture 5.
3. Turn on general power and move power switch to "ON" position.
Advertisement
