Table of Contents
Advertisement
Read this manual carefully before using the product and follow the instructions and
recommendations included herein. Refer to ctrl4.co/ds2mini for full documentation on this IP
intercom.
What you need for mounting
LAN connection, Cat5e or higher UTP cable with RJ-45 connector
-
PoE 802.3af or 12VDC/2A power supply
-
Installation procedure
1.
Choose an installation site easily accessible to users.
2.
Check the cable connection options.
3.
Prepare the cables, LAN connection, power supply and lock/accessory wiring, if
necessary.
4.
Remove the device from the package and install it as instructed in these
instructions.
5.
Connect the cables and make sure that the device works correctly.
6.
Mount the device to the base.
Caution
When the proper mounting instructions are not met, water might get in and destroy the
-
electronics. The intercom circuits are constantly powered and water infiltration causes
an electro-chemical reaction. The manufacturer's warranty will be void for products
damaged in this way!
Electric installation–Description of connector terminals
Description of motherboard connectors accessible to users:
802.3af LAN connector
-
IN1 input terminals in passive/active mode (-30 to +30VDC)
-
OFF = open contact OR U
ON = closed contact OR U
OUT1 active output: 8 up to 12VDC, depending on the power supply (PoE: 10V;
-
adapter: supply voltage -2V), up to 400mA
RELAY terminals for 30V/1A AC/DC NO/NC contact
-
External 12/2A DC power supply terminals
-
Grounding terminal
-
RESET and FACTORY RESET button
-
LED state indicators (red / device state / green – Ethernet connection / yellow – LAN
-
activity)
> 1.5V
IN
< 1.5V
IN
2
Hide quick links:
Advertisement
Table of Contents
