Equinox Systems Stage Haze 1500 User Manual page 5

On startup the LCD display will show the heating percentage up to completion 'heating 0%' to 'heating
100%' whilst the unit is heating up and performing its startup clean cycle (approx. 3 minutes).
Once the heating up is finished it will then display 'Machine ready', which means the unit
is ready for use.
Timer mode:
Press the "FUNCTION" button on the unit to display 'Wait Time Set Mode:', you can now adjust the
interval time from 1s to 600s by using the and buttons.
Press the "FUNCTION" button to display 'Start Time Set Mode:', you can now adjust the haze output time
from 1s to 600s by using the and buttons.
Press the "FUNCTION" button to display 'Timer Smoke Volume Out:', you can now adjust the output
volume from 0% to 100% by using the and buttons.
Press the "FUNCTION" button to display 'Fan Adjusting Volume:', you can now adjust the fan volume
from 0% to 100% by using the and buttons.
Once set you can then use the timer button to enable this mode.
The display will show
'Haze wait: ___S
Haze start: ___S'
with the settings already applied.
Press the button once to stop haze output.
Manual mode:
VOLUME
Press the button to start manual haze.
PUMP/FAN
The display will show the current settings eg '*Haze 50% Fan 100%'.
You will notice an * will appear next to the word *Haze, you can now adjust the setting accordingly using
the and buttons. If you want to adjust the Fan, simply press the FUNCTION button and the * will
appear next to the word *Fan you can now adjust the setting accordingly using the and buttons.
Press the button once to stop haze output.
Please note: This mode is for continuous haze.
button:
Press the button until the LCD display shows 'Do not off in clean 300S'. The unit will now perform
its cleaning cycle. Once the LCD display shows 'To turn off the POWER!!!', you can then disconnect the
unit from the mains power supply.
www.prolight.co.uk
Operating instructions Operating instructions
Stage Haze 1500 User Manual
5