Hahnel MODUS 600RT Instruction Manual
Wireless speedlight for sony
Hide thumbs
Also See for MODUS 600RT:
- Manual (192 pages) ,
- Instruction manual (176 pages) ,
- Instruction manual (26 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Hahnel MODUS 600RT
Summary of Contents for Hahnel MODUS 600RT
- Page 1 English Wireless Speedlight for Sony Instruction Manual Modus 600RT...
-
Page 2: Table Of Contents
Contents Foreword Page Thank you for purchasing the hähnel Modus 600RT. 1 Introduction • Safety precaution - Warnings & Cautions • Before starting to shoot, be sure to read this manual • Nomenclature • When reading this manual also refer to the camera’s •... -
Page 3: Introduction
Battery temperature while on charge or in use should never increase above 60ºC/140ºF. If higher temperature occurs, stop using and stop charging immediately • Do not use paint thinner, benzene, or other organic solvents to clean the product Modus 600RT Modus 600RT... -
Page 4: Nomenclature
07. Sync Cord Jack 02. Built-in Wide Panel 08. USB Port 03. Flash Head 09. Hotshoe 04. Optical Control Sensor 10. Dot-matrix LCD Panel 05. Focus Assist Beam 11. Battery Compartment 06. Slave Flash Ready Indicators 12. Lock Wheel Modus 600RT Modus 600RT... -
Page 5: Control Panel
:Master unit bounce ON wireless shooting change according to settings’ status. : Master • When a button or dial is operated, the LCD panel illuminated. 16. Flash mode : <blank>, 19. Master Group: Mode <MULTI> 20. A.B/C Group: Mode Modus 600RT Modus 600RT... -
Page 6: Lcd Panel In Five Modes
(C) Group C (6) Power / Status LED (1) ON/OFF - switch (7) Hot shoe (2) SEL - select button (8) Test - button (3) Adjust Dial - To adjust settings (9) Micro USB - firmware update Modus 600RT Modus 600RT... -
Page 7: Viper Ttl Transmitter
For optimum battery life use battery regularly and if not used for more than 6 months charge the battery fully and use it with the Modus 600RT until the battery level is down to 1 bar again before storage. -
Page 8: Attaching To Camera
Disabling Auto Power Off function is recommended when the flash is used off camera. (C.Fn-APO) Slave Auto Power Off Timer is set to 60 minutes by default. Another option “30 minutes” is available. (C.Fn-Sv APOT, Page 33) Modus 600RT Modus 600RT... -
Page 9: Flash Mode - Ttl Autoflash
In this mode, multiple TTL functions are available: FEC, FEB, FEL, HSS, second curtain sync, modeling flash. These can be controlled with the Modus 600RT or with the camera’s menu screen. FEB: Flash Exposure Bracketing The Flash Exposure Bracketing can be set from your camera. Please... -
Page 10: Flash Output Power Range
With stroboscopic flash, a rapid series of flashes is fired. It can be used to capture multiple images of a moving subject in a single photograph. You can set the firing frequency (number of flashes per sec.expressed as Hz), the number of flashes, and the flash output power. Modus 600RT Modus 600RT... -
Page 11: Master/Slave Wireless Flash Lighting
• The “Master” attached to the camera can be a “Modus 600RT” or “Viper TTL transmitter” • Use the supplied mini stand to hold the Slave unit in upright position • Before shooting perform a test falsh and test shooting •... -
Page 12: Wireless Settings
You can switch between normal flash and wireless flash. For normal flash shooting, be sure to set the wireless setting to OFF Initialy the Modus 600RT wireless 2.4GHz is set to a general “open channel” and can be used as it is. To avoid interference with other... -
Page 13: Modus 600Rt Reset
6 Check the Master slave Modus 600 RT - Reset speedlight operation • To reset the Modus 600RT to • Press the master unit’s < > factory default settings press test button function buttons 3 & 4 at • The slave speedlight will the same time and hold until flash. -
Page 14: Multiple Master Unit
/ B / C Page 22 • Press Function Button 3 4. Set the flash output >. Then turn the and flash exposure < compensation amount Select Dial to set the group • While a firing group is ON/OFF selected, press Function Modus 600RT Modus 600RT... -
Page 15: Setting The Optical Communication Channel
(WL) mode. • If a Sony branded flash unit is communicating wireless optical with Modus 600RT, set it to WL CTRL on the flash menu when it is a Master Photography: - and set it to WL RMT on the flash menu when it is a Slave. Refer to the flash unit manual for details. -
Page 16: Dcm (Digital Channel Matching)
10 consecutive times. If you fire the modeling 2. Set the Modus 600RT to 2.4GHz as Slave Unit - Group A, see flash 10 consecutive times, allow at least 10 minutes’ break for the camera page 23 flash. -
Page 17: Zoom - Setting The Flash Coverage And Using Wide Panel
If this occurs, allow a rest time of about 10 minutes, and the flash unit will then return to normal • When the over-temperature protection is active, < > is shown on the LCD display Modus 600RT Modus 600RT... -
Page 18: Technical Data
Number of Number Technical Data Power Output level of Flashes flashes that will activate over- Modus 600RT temperature 1/2 +0.7 Sony DSLR cameras (TTL auto flash) protection: 1/2 +0.3 1/4(+0.3,+07) 1/8(+0.3,+07) 1/16(+0.3,+07) 1/32(+0.3,+07) 1/64(+0.3,+07) 1000 1/128(+0.3,+07) Number of flashes that will TTL autoflash and manual flash... -
Page 19: Troubleshooting
• →If the flash ready indicator lights up, but < > or < > is not • For up to date compatibility of all camera models check www.hahnel.ie displayed in the view finder, check whether this flash unit is securely attached to the camera hotshoe. -
Page 20: Modus 600Rt
Toutes les spécifications du produit sont sous réserve de modifications S.E.O.O. All brands, trademarks and registered trademarks are the property of their respective holders. Copyright © hähnel industries Ltd, Ireland. A product of hähnel industries ltd., Ireland. Made in China Rev: 03/17 Modus 600RT...
Need help?
Do you have a question about the MODUS 600RT and is the answer not in the manual?
Questions and answers