VAMP The Quick Manual

Bluetooth speaker adapter

Advertisement

Quick Links

®
QUICK GUIDE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the The Vamp and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for VAMP The Vamp

  • Page 1 ® QUICK GUIDE...
  • Page 2 Use an old speaker in a way you've never used it before. Transform it into a portable Bluetooth® speaker using The Vamp®. You can position The Vamp® anywhere on your speaker. Stick the metal disc provided onto your speaker and The Vamp® will be held magnetically in place.
  • Page 3: Led Status

    Micro USB charge port Audio input Speaker connector On/off button LED STATUS Solid RED Low battery Solid RED Charging LED off Fully charged Flashing RED and BLUE Pairing mode Play (via bluetooth) LED flashes BLUE Play (via cable) LED is off...
  • Page 4: Get Started

    Make sure The Vamp® is fully charged before using. Charge The Vamp® using the USB charge cable provided. Plug the micro USB into The Vamp® and the USB into the USB port of your computer or phone charger. When charging the LED will be a solid red. The LED will go off when fully charged.
  • Page 5 FIND ANY SPEAKER Any passive speaker can connect to The Vamp®. Some backs of speakers are like this...with speaker or like this...with a wire terminals...
  • Page 6 CONNECT THE VAMP® Using the speaker cable provided, connect the wires into the terminals of the speakers and into the speaker connectors of The Vamp®.
  • Page 7 Connect the cables from the speaker into the speaker connectors of The Vamp®.
  • Page 8: Play Via Bluetooth

    If you don’t hear the ‘on’ tone, the speaker might not be connected properly. Turn The Vamp® off and reconnect the speaker. The Vamp® will go into pairing mode and the LED will flash blue and red alternatively. It will search for a device continuously.
  • Page 9 PAIR TO A DIFFERENT DEVICE Turn off the Bluetooth® on the previously connected device. The Vamp® will enter pairing mode and repeat steps 1 - 2 using the new device. Please see the Troubleshooting section or visit our website if...
  • Page 10 Hold down the power button for 4 seconds and wait for the ‘on’ tone and the LED to turn on. Connect The Vamp® to a speaker. Plug the 3.5mm audio jack cable provided into the headphone jack of your device and into the audio jack...
  • Page 11 BE LOUDER CONNECT TWO SPEAKERS Connect wires from both speakers into the speaker connectors of The Vamp®.*...
  • Page 12 Please note: • This option will reduce the battery life. • Connecting two speakers to The Vamp® will not give stereo sound. The output is mono. • Connecting speakers in series is not recommended. • Do not allow the wires to touch.
  • Page 13: Troubleshooting

    Bluetooth® range. After 5 mins of connection loss it will go back into pairing mode. If necessary, turn off The Vamp® and your device. Switch both on and reconnect. If there is sound distortion: •...
  • Page 14 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
  • Page 15 To ensure your personal safety and damage to the product please read the following safety warnings. Do not expose The Vamp® to extreme conditions i.e: extreme hot or cold weather, humid or wet conditions. Do not attempt to disassemble The Vamp® or remove the battery.

Table of Contents