Whirlpool WDT710PAHZ User Instructions page 9

OPTION SELECTIONS
Runs dishwasher at a later time. Select a wash
cycle and options. Each time you press the
Delay keypad, it will display the next available
delay time. Press DELAY. Press the START/
RESUME keypad. Close door firmly.
NOTES:
The dishwasher remembers the last Delay
■
you selected. To reset the delay time to
something other than what is displayed,
continue to press the Delay keypad until the
desired delay time is reached.
Any time the door is opened (such as, to add
■
a dish), Start/Resume must be pressed again
to resume delay countdown.
Sanitizes dishes and glassware in accordance
with NSF International NSF/ANSI Standard 184
for Residential Dishwashers. Certified residential
dishwashers are not intended for licensed food
establishments. Only sanitizing cycles have
been designed to meet the requirements of the
NSF/ANSI 184 performance standard for soil
removal and for sanitization efficacy. There is
no intention, either directly or indirectly, that all
cycles on a NSF/ANSI 184 certified dishwasher
meet the NSF/ANSI 184 performance standard
for soil removal and for sanitization efficacy.
At end of the cycle, the "Sanitized" indicator will
glow. If your load did not properly sanitize, the
indicator will flash at the end of the cycle. This
can happen if the cycle is interrupted or if the
water does not reach the required temperature.
The light goes off when you open and close the
door or press CANCEL.
Dries dishes with heat. This option, with the
use of rinse aid, will provide better drying
results. Plastic items are less likely to deform
when loaded in the top rack. Use Heat Dry for
optimum drying performance. For air dry, Heat
Dry LEDs are off.
Raises the main wash temperature to improve
cleaning for loads containing tough, baked-on
food.
Use the Control Lock option to avoid unintended use of dishwasher between cycles or cycle and option changes
during a cycle.
To turn on Control Lock, press and hold CONTROL LOCK for 3 seconds. Control Lock light will stay on for a short
time, indicating that it is activated. When the Lock indicator is lit, all buttons are disabled. If you press any button
while your dishwasher is locked, the light flashes three times. The dishwasher door can still be opened/closed while
the controls are locked.
To turn off Control Lock, press and hold CONTROL LOCK for 3 seconds. Control Lock light turns off.
OPTIONS CAN BE WHAT IT DOES ADDED
SELECTED
WITH
Available with Delays start of
any cycle a cycle up to
24 hours.
Sensor Raises the main
Heavy wash temperate
Normal to135°F (57°C)
and the final rinse
temperature to
(156°F (69°C).
Sensor
Uses a heating
Heavy
element to speed
Normal
drying times.
1 Hr Wash
Heat Dry option
Soak & Clean
defaults to On
when any cycle is
selected, except
for 1 Hr Wash.
Sensor Raises the main
Heavy
wash temperate
Normal
to135°F (57°C).
Soak & Clean
ADDED
TIME TO WATER
CYCLE GALLONS
(LITERS)
NA NA
0:05 to 1:06 0 to 3.9
(0 to 14.6)
NA NA
0:05 to 0:13 0 to 3.9
(0 to 14.6)
9