Related Manuals for Christie BC-RAD7X
Summary of Contents for Christie BC-RAD7X
- Page 1 BATTERY TORQUE WRENCH (BC-RAD-X) USER GUIDE Ref: WCOI.076 Date: 01/06/2015 Issue: 5...
-
Page 2: Table Of Contents
Reaction Arm 240V or 110V electrical battery charger (dependant on model purchased) If the intended use is other than for nuts, bolts and threaded fasteners contact W. Christie (Industrial) LTD for guidance. It is the responsibility of the user to consider associated site risks before introducing the equipment into... -
Page 3: Training Requirements
PRIOR TO USE. FOR APPLICATIONS OF A CRITICAL NATURE, BC-RAD- X WRENCHES MUST BE TORQUE CHECKED DAILY. W. CHRISTIE (INDUSTRIAL) LTD OFFER A TORQUE CHECKING SYSTEM (RUN DOWN FIXTURE) FOR SALE OR HIRE TO MONITOR THE TORQUE OUTPUT OF ALL TORQUE TOOLS BETWEEN ANNUAL... -
Page 4: Battery Pack Safety
BATTERY PACK SAFETY Do not attempt to charge a fully charged battery pack. Disconnect immediately if there is any sign of smoke or flames. Keep battery packs dry at all times. Do not store in direct sunlight. Do not expose to fire or immerse in water. ... -
Page 5: Accessories Available To Buy Or Hire
ACCESSORIES AVAILABLE TO BUY OR HIRE The following accessories are available upon request and can be custom made to suit requirements. Please contact W. Christie (Industrial) LTD for more information:- Special Reactions. Nose Cone Extension. Offset Gearbox. -
Page 6: Torque Reaction
TORQUE REACTION When the Christie BC-RAD-X wrench is in operation the reaction arm rotates in the opposite direction to the output square drive and must be allowed to rest squarely against a solid object or surface adjacent to the bolt to be tightened. (See Figure Below). -
Page 7: Safe Reaction Zone
If the application does not allow the use of a standard reaction arm, non-standard reaction arms are available. Customers must not modify reaction arms and are strongly advised to contact W. Christie (Industrial) LTD technical assistance. -
Page 8: Setting Torque For Bolt Tightening
SETTING TORQUE FOR BOLT TIGHTENING 1) Ensure The battery pack and reserve battery are fully charged (see “Battery Sample BC-RAD-X Torque Calibration Certificate (Nm) Charging” section) Setting Torque 2) Set the Direction Selector Switch (D) to forward. 3) Identify the torque required for the bolting application. - The BC-RAD Wrench comes with a torque calibration certificate. -
Page 9: Operating The Wrench
W. Christie (Industrial) LTD immediately on +44 (0)1709 55 00 88 W. Christie (Industrial) LTD Offer a torque checking system (run down fixture) for sale or hire to monitor the torque output of all torque tools between annual calibration dates. -
Page 10: Battery Charging / Changing
BATTERY CHARGING / CHANGING To remove the Battery Pack (B) from the BC-RAD-X wrench press the Battery Release button on the rear of the tool handle and pull the battery pack (B) from the Wrench. To install a new Battery Pack (B) to the BC-RAD-X wrench push the battery back into the wrench handle until it clicks in place. -
Page 11: E.c. Declaration Of Conformity
European Machinery Directive 2006/42/EC published on the 9 June 2006 W Christie (Industrial) Ltd, Meadowbank Road, Rotherham S61 2NF, United Kingdom. This machinery has been designed and manufactured in accordance with the following transposed harmonised European Standard:- Safety of Machinery –...
Need help?
Do you have a question about the BC-RAD7X and is the answer not in the manual?
Questions and answers