Assembly Procedure - Panasonic H-H025PP Service Manual

6.5.

Assembly procedure

Important:
1. When tightening the screw, use a torque driver
(RFKZ0456) by ordering the screwing order with specified
torque described in each step.
2. Mounting that the Filter Ring and the Rear Frame Unit as
Lens fitting mark are aligned.
6.5.1. Installation of the Filter Ring Unit
and the Dust Proof Ring
1. Mounting that the Filter Ring as Lens fitting mark are
aligned.
2. Tighten 3 screws (A) by using the torque driver with spec-
ified torque.
3. Install the Dust Prooof Ring.
6.5.2. Installation of the Deco. Ring Unit
1. Please insert the 3 protrusions of the Deco. Ring Unit
back to 3 holes of the Filter Ring.
(Caution)
• Use new one, do not use the one which is removed.
• Please remove the old double-stick tape from the Lens
Unit.
2. After installing the Deco. Ring Unit use a soft cloth to
Press it into place.
12