Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Kroeplin G Serie
Summary of Contents for Kroeplin G Serie
- Page 1 Quick reference guide Electronic measuring instruments The quick reference guide does not replace the user’s manual. The initial operation and operating instructions of the user’s manual must be strictly observed. Electronic series...
- Page 2 Important: The measuring axis must be in vertical position to the measuring surface! The measuring axis must be in central position to the bore! Operating key: – short (max. 2s) – long (min. 2s) The initial state is precondition for all functions of described programs and settings Switch from „Absolut-Mode“...
- Page 3 Starting tolerance check Adjusting tolerance range Finishing tolerance check Zero point adjustment Changing sign (-/+) / digit Next digit Confirming Exit SETUP menu Switching mm/inch (UNIT) Error Report: ERR 01 – Unknown Input (Input is not supported) ERR 02 – Unknown Input (Input is not supported) ...
- Page 4 You thereby fulfill your legal obligations and make a contribution to environmental protection. Note: Kroeplin assumes no liability to any party for any loss or damage, direct or indirect, caused by use of this instrument not conforming to this manual.
Need help?
Do you have a question about the G Serie and is the answer not in the manual?
Questions and answers