Vent-Axia HR500IP Installation Instruction
Vent-Axia HR500IP Installation Instruction

Vent-Axia HR500IP Installation Instruction

Passive semi-remote wall mounted heat recovery unit with spigot connections.

Advertisement

Quick Links

HR500IP
Passive Semi-Remote
Wall Mounted Heat Recovery Unit
with Spigot Connections.
Installation Instructions
PLEASE RETAIN THESE INSTRUCTIONS WITH THE PRODUCT.
Stock Ref. N°
370447
Copyright © 2009 Vent-Axia Limited. All rights reserved.
-
HR500IP

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HR500IP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Vent-Axia HR500IP

  • Page 1 HR500IP Passive Semi-Remote Wall Mounted Heat Recovery Unit with Spigot Connections. Installation Instructions Stock Ref. N° 370447 HR500IP PLEASE RETAIN THESE INSTRUCTIONS WITH THE PRODUCT. Copyright © 2009 Vent-Axia Limited. All rights reserved.
  • Page 2 Warnings & Safety Information 5. This appliance is not intended for use by persons (including children) IMPORTANT SAFETY with reduced physical, sensory or INFORMATION mental capabilities, or lack of experience and knowledge, unless PLEASE READ THESE they have been given supervision or INSTRUCTIONS instruction concerning use of the CAREFULLY BEFORE...
  • Page 3 Introduction The Vent-Axia HR500IP unit is designed for mounting in internal walls for installations using ducted extraction and fresh air supply. Air movement is achieved by using in-line duct fans or wall mounted units to suit the length and configuration of ducting systems.
  • Page 4 Installation The HR500IP unit should be set in an inner wall with the grille flange set flush with the inner surface (a steel lintel is provided for additional support of the building fabric if required). If used this will automatically produce a 3° slope of the unit away from the inner grille for drainage of any condensate which may form during operation.
  • Page 5 Maintenance & Cleaning The HR500IP unit requires only occasional cleaning. By depressing the two buttons on either side of the internal grille, the grille, pre-filters and heat exchanger can be easily removed and cleaned by using a vacuum cleaner or by washing in luke warm soapy water.
  • Page 6 Activating the Timestrip. 1. Activation: Fully squeeze the activation button between thumb and finger. A red line will appear within 1-2 minutes to show that the Timestrip has been activated. 2. Peel off the backing liner and stick the Timestrip to the Unit or near the controls of the unit. The location should make it obvious to the person responsible for maintenance that the unit needs attention.
  • Page 7 Product FICHE PRODUCT FICHE For Residential Ventilation Units (Complying Commission Delegated Regulation (EU) No 1254/2014) Name: Vent-Axia Model ID (Stock Ref.) : HR 500 IP - 370447 SEC Class SEC Value ('Average') -39.00 SEC Value ('Warm') -17.84 SEC Value ('Cold') -76.72...
  • Page 8 For details of guarantee outside the United Kingdom contact your local supplier. Vent-Axia guarantees its products for two years from date of purchase against faulty material or workmanship. In the event of any part being found to be defective, the product will be repaired, or at the Company’s option replaced, without charge, provided that the product: ...

Table of Contents