Subscribe to Our Youtube Channel
Related Manuals for Painless Performance 50001
Summary of Contents for Painless Performance 50001
-
Page 1: Installation Instructions
Wire Harness Installation Instructions For Installing: Part #50001 – Race Car Kit/10 Circuit Part #50201 – 8 Switch Dash Mounted Panel Part #50202 – 8 Switch Roll Bar Mounted Panel Manual #90502... - Page 2 2.0 ABOUT THESE INSTRUCTIONS These instructions provide information for the installation of the 50001 10-circuit competition Wire Harness Kit, and the 50201/50202 10-circuit Switch Panel. The contents of these instructions are divided into major Sections,...
- Page 3 Whenever a particular harness section is referred to in these instructions it is shown all caps. 4.1.1 The two SECTIONS of the 50001 10-Circuit Competition Wire Harness Kit are listed immediately following. The 50201/50202 10-Circuit Switch Panel wire assignments are not separated into SECTIONS.
- Page 4 5.2 INSTALLATION AND CONNECTIONS (Refer to Table 5.1) 5.2.1 General (Connecting the 50001 harness to other than 50201/50202) A. Mount the 50001 Fuse/Relay Block in the desired interior location. Route the INSTRUMENT PANEL SECTION wires to the activating switches. See Table 5.1 and terminate the wires as shown.
- Page 5 5.3 RELAY PLACEMENT See Figure 5.2. Figure 5.2 50001 Relay and Fuse Placement 6.0 CONNECTING 50001 TO 50201/50202 10-CIRCUIT SWITCH PANEL 6.1 CONTENTS OF THE SWITCH PANEL KIT Take inventory to see that you have everything you're supposed to have in this kit. If anything is missing, go to the dealer where you obtained the kit or contact Perfect Performance Products, Inc.
- Page 6 C. Using the proper crimping tool, install the provided (female) receptacle contacts onto the 50001 Instrument Panel Section wires according to Table 6.2 and insert the contacts into the connector plug provided. NOTE: We have provided you with 3 additional terminals in case any become damaged during installation.
- Page 7 Table 6.2 Connector pin-out...
- Page 8 Chassis harnesses, fuel injection harnesses are covered under a lifetime warranty. All other products manufactured and/or sold by Painless Performance are warranted to the original purchaser to be free from defects in material and workmanship under normal use. Painless Performance will repair or replace defective products without charge during the first 12 months from the purchase date.
Need help?
Do you have a question about the 50001 and is the answer not in the manual?
Questions and answers