Philips QP6510 User Manual page 4

5 Switch off and clean the appliance after every
use (see 'Cleaning and maintenance').
6 To remove the comb, pull the back part off the
appliance and then slide the comb off the
blade (Fig. 20).
Cleaning and maintenance
Clean the appliance after every use.
Caution: Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the appliance.
Caution: Do not tap the appliance against a
surface to remove water from it, as this may cause
damage (Fig. 19). Replace the blade immediately
if it is damaged.
Cleaning the appliance
1 Switch off the appliance.
2 Remove the comb from the blade (Fig. 20).
Always turn the appliance off before putting on
or taking off the comb.
3 If a lot of hairs have accumulated on the comb,
first blow them off (Fig. 21).
4 If a lot of hairs have accumulated on the
appliance, first blow them off (Fig. 22).
5 Then switch on the appliance and rinse the
blade with lukewarm water (Fig. 23).
Caution: Do not dry the blade with a towel or a
tissue as this may cause damage.
6 Then rinse the comb with lukewarm water (Fig.
24).
7 Let the appliance and comb dry.
Note: The blade is fragile. Handle it carefully.
Replace the blade immediately if it is damaged.
Storage
Note: We advise you to let the appliance and its
attachments dry before you store them for the next
use.
1 Always attach the precision trimming comb on
the blade to protect the blade from damage
during traveling or storage (Fig. 15).
Replacement
Replacing the blade
For optimal cutting and gliding performance, we
advise you to replace the blade every 4 months or
when it no longer provides the shaving or trimming
results you expect. The advice of replacing every 4
months is based on two full shaves a week.
Depending on your usage behavior the exact
lifetime of the blade could be longer or shorter.
Similar to what you would experience with a
manual blade, the blade becomes blunt over time,
which results in increased hair pulling and reduced
cutting performance.
1 Switch off the appliance.
2 Push the blade release slide upwards carefully,
and hold the blade on its sides to remove the
blade and prevent it from flying away (Fig. 25).
3 Hold the new blade on both sides and press it
onto the handle ('click') (Fig. 26).
Note: When you hear a 'click' the new blade is
placed correctly and ready for use.
Ordering accessories
To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your
Philips dealer. You can also contact the Philips
Consumer Care Center in your country (see the
international warranty leaflet for contact details).
The following parts are available:
- QP210 Blade 1-pack
- QP220 Blade 2-pack
Disposal
- This product contains a rechargeable lithium-
ion battery which must be disposed of properly.
- Contact your local town or city officials for
battery disposal information. You can also call
1-888-224-9764 or visit www.call2recycle.ca
for battery drop-off locations.
- For assistance, visit our website
www.philips.com/support or call
1-800-243-3050 toll free.
- Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused. For
recycling information, please contact your local
waste management facilities or visit
www.recycle.philips.com.
Removing the rechargeable battery
Caution: Only remove the rechargeable battery
when you discard the appliance. Make sure the
battery is completely empty when you remove it.
Note: We strongly advise you to have a
professional remove the rechargeable battery.
1 Disconnect the appliance from the mains and
let the appliance run until the motor stops.
2 Remove the blade from the appliance.
3 Insert a screwdriver under the back panel and
remove the panel.
4 Break the snap connections on both sides with
the screwdriver.
5 Push out the inner body by pushing the
screwdriver into the bottom of the handle.
- Now you see the printed circuit board.
6 Remove the cover of the printed circuit board
with the screwdriver.
7 Remove the printed circuit board from the inner
body with the screwdriver.
8 Lift the battery out of the inner body with the
screwdriver. The battery is connected with
double-sided tape.
Warning: Be careful, the battery strips are
very sharp.
Warranty and support
If you need information or support, please
www.philips.com/support or call toll free:
1-866-800-9311. To locate the nearest Philips