Table of Contents
Advertisement
WAN Settings: Specify the Internet access method to Static IP, DHCP or PPPOE. Users must enter
WAN IP Address, Subnet Mask, Gateway settings provided by your ISPs.
LAN Settings: When DHCP Server is disabled, users can specify IP address and subnet mask for
KWA-O6020-I manually. Make sure the specified IP address is unique on your network in order to
prevent IP conflict. When DHCP Server is enabled, users may specify DHCP IP Address Range,
DHCP Subnet Mask, DHCP Gateway and Lease Time (15-44640 minutes).
!!!Warning:
In AP mode, KWA-O6020-I must establish connection with another wireless device before it is set to
Router mode. In Router mode, it is impossible for users to access device via wired port, for WAN is on
wired port and LAN is on wireless port. Users can access device through the wireless device
connected with KWA-O6020-I .
In CPE mode, users can access KWA-O6020-I via its wired port, for WAN is on wireless port and LAN
is on wired port when device is set to Router mode.
WDS mode and AP Repeater mode are similar to AP mode when device is set to Router mode; WAN
is on wired port and LAN is on wireless port. Thus users must also connect KWA-O6020-I with
another wireless device before it is set to Router mode and access KWA-O6020-I via the connected
wireless device.
Figure 6 IP Settings (Router)
Advertisement
Table of Contents
