InisBofin Insert Roomheater InisBofin Roomheating Insert Stove User and Installation Manual The instruction satisfies relevant local, national and European standards...
We wish you success in use of it! “JSC BIOKAITRA” The insert “InisBofin Roomheater ” is designed for heating residential and public areas. This stove contains a modern construction and ensures long term usage while using it properly. The insert “InisBofin Roomheater” conforms to LST EN 13229 standard requirements.
InisBofin Insert Roomheater Congratulations on the purchase of your new InisBofin room-heating Fume emissions into the room insert stove. We here at Inis must not be tolerated Stoves truly love building high If this happens close the door of quality stoves for our customers.
InisBofin Insert Roomheater Stove Features As per Fig 1 below the door of the stove is opened by inserting the narrow end of the hand tool into the door latch and lifting the handle upwards. The hand tool in this position can then be used to move the door as required.
InisBofin Insert Roomheater and when igniting the stove. If When the stove is used for the excess fuming to the room results first number of times the process at any time when the door is of curing the paint will occur. To...
Page 7
Ideally, empty the ash pan maximum diameter of when the ashes are cold. approximately 100 mm. 7. Inis Stoves is dedicated to the principal of using wood Don’t burn coal pellets or coal logs in all our stoves. dust. Burning slack is not Using wood logs as fuel goes recommended.
Slow burning a bright high temperature fire should result. Once the fire is Your InisBofin is capable of slow well alight the door can be fully burning making overnight burning closed. Since Wood logs are used possible at a reduced output.
InisBofin Insert Roomheater be opened up as necessary. To avoid Stove cleaning and excessive blackening of the glass maintenance the damper should be left slightly open. To revive the fire after overnight Regular cleaning is essential for burning, riddle the grate, refuel...
Page 10
Inspect all internal parts of the Fig 4 stove and replace if needed. Only Inis Stoves or an approved Engineer on our behalf should modify the stove in any way.
Inis Bofin Insert Roomheater To clean the paint of the stove we 2 Fuel load too small for damper recommend the use of a damp cloth setting. containing some mild detergent. 3 Door seals are worn. Avoid using abrasive material on the paint of the stove.
Page 12
InisBofin Insert Roomheater by oscillating the grate back and the use of wet or improper fuel forth without excessive force will often lead to excessive glass blackening. Often clean glass being used. The grate is not operation will be attained with a designed to fully close when burning wood logs.
• If we still have an issue that hasn’t been resolved, please contact Inis Stoves technical department. Please have this manual with you when you call...
InisBofin Insert Roomheater Technical Specifications Name Units Inis Bofin Fuel used * wood logs Max. measurements of wood logs Ø90 x 330 Please ensure that the Efficiency at nominal heat output installation of the stove Nominal heat output complies with all the CO concentration (at 13% O₂)
InisBofin Insert Roomheater In addition to installation opening the door and lifting up instructions supplied, the approx. 20mm until the hinges are requirements of BS.8303 and clear and lift away. Take great BS.6461 Parts 1&2; 1984 must be care not to drop the door as it is fulfilled.
InisBofin Insert Roomheater Fig 6 the chimney should be lined with a cleaned again as soot previously secure may come loose as the flue suitable flue liner for wood logs. All chimneys and flues used must gas from the stove is quite...
Page 17
InisBofin Insert Roomheater Fig 8 shows the minimum distances for class 1 appliances. As can be to combustibles. seen below in Fig 7 the minimum sizes of the opening are shown with minimum hearth thickness. Fig 7 Fig 8...
InisBofin Insert Roomheater The minimum depth of the recess into the flue and not down around for the stove from the front face the stove body. The extension should be 365mm. In most cases piece of flue is now pushed fully...
Page 19
InisBofin Insert Roomheater section down the chimney and pull the installation of the flexible down onto the flue collar. The liner at the top of the chimney as flexible liner MUST fit into the per the manufacturer’s adaptor on the straight flue piece instructions.
InisBofin Insert Roomheater Method 2 Air Requirement Care must also be taken to ensure that the vent cannot be blocked by object left against the wall Due to the increase in building outside or debris like leaf litter air tightness particular attention etc.
InisBofin Insert Roomheater Pre-firing checks First Firing & Commissioning The sealing material in the flue connections and any mortar used in A small fire can now be started in the installation will require some the stove. Use only small pieces time to set fully.
Need help?
Do you have a question about the InisBofin and is the answer not in the manual?
Questions and answers