Controls; Fixed Volume Mode; Auto Aux Input Mode - MartinLogan Unison User Manual

c
ontrols
POWER: Press and release to turn the
product on/off.
Press and hold the power button for 3 seconds to
reboot your wireless product.
Press and hold the power button for 10 seconds to
reset your wireless product to factory settings and
clear the network configuration.
Your wireless product will enter Standby Mode
(reduced power consumption) after 20 minutes
of no music playing. It will automatically wake-up
when it senses music being received. The Power
button will stay illuminated whether the unit is pow-
ered on or in Standby Mode. If there is a power
failure while your wireless product is switched on, it
will switch back on once power has been restored.
VOLUME UP / DOWN:
Press once to turn volume up/
down. Press and hold to ramp the volume up/down.
MUTE: Press and release to mute the
MartinLogan wireless product. Pressing
this button a second time or pressing either volume
button will restore the previous volume setting.
If you are using ARC™ (Anthem Room Correction)
press and hold the mute button for 5 seconds to
turn off ARC on/off. A 'negative tone' will sound
to verify ARC is switched off. A 'positive tone' will
sound to verify ARC is switched on. If no ARC cor-
rections are loaded on the speaker it will make a
quiet thumping sound.
10
INPUT: Switches to the rear panel auxilia-
ry input. This button illuminates white when
streaming mode is enabled and blue when the auxil-
iary input is enabled. If the wireless product is set to
analog input and detects a new audio stream, it will
automatically switch to streaming mode.
WI-FI INDICATOR: The Wi-Fi Indicator tells you
what your wireless product is doing.
• Rapid Blinking: booting up.
• Blinking: connecting to a wireless router.
• Slow Pulse: Access Point Setup Mode.
• Two Blinks & Pause: WPS (Wi-Fi Protected
Setup) Mode.
• Solid: Connected to a wireless router.
• Off: Connected to a router via Ethernet.
FIXED VOLUME MODE: When fixed level is
on, the output volume level of the unit is set to a
fixed level for sources connected to the analog in-
put. Fixed volume also applies to the Play-Fi source.
To enable fixed volume mode hold the volume
down and mute buttons for five seconds. Hold them
again for five seconds to cancel.
AUTO AUX INPUT MODE: Unison can be
configured to automatically select the Auxiliary
input when DTS Play-Fi is turned off. This mode
can be useful when using the Unison to improve TV
audio. To enable auto input mode hold the input
button for five seconds. Hold it again for five sec-
onds to cancel.