Advertisement
Cut and fit Unscribed Dash Siding (24) which is Pre-Cut to height
and cement it to the Window Sections.
Cut and fit the Window Sills (25) from Stripwood with one end
colored Yellow. Cement on Top of the Dash. Sand the window
sills to leave a slight projection.
Remove the Tension of the End Letterboard Overlay, (28) made
from Stripwood with the Combination colors Blue and Green,
by rolling a small round object back and forth on the Backside.
Center and cement to the End Radius, keeping it flush at the top.
Cut and Cement the Bevel Casing (26) in place, from Stripwood
with one end colored Red. This casing goes next to the end door
Cut and Cement the Bevel Casing (27) in place, from Stripwood
with one end colored Green. This casing goes against the outside
of the end next to the Passenger Doors. Make sure that the "square
edge" and "wide face" are out.
.
Red Ends
Green Ends
Cut out or trace Template "E" and sand the end letterboards
to this radius, Flush with the center and corner moldings.
9 10
12
11
Assemble the roof (29) by cementing the window inserts (30)
inside the roof.
Cut the casing (31) to length from the Stripwood colored one end
Brown.
Cut the casing (32) to length from the Stripwood colored both
ends Blue.
Cement in Place.
Sand the Roof to the correct length, leaving an equal overhang
at the sides and ends.
4
Sand here
Both ends Blue
Brown End
Advertisement
