Installing And Charging The Batteries - Sandstrom SWHP12 Instruction Manual

Installing and Charging the Batteries

1. Remove the battery cover and insert 2 x rechargeable AA batteries (included) into the
battery compartment. Replace the battery cover.
2. Switch off the headphone and place it into the transmitter contacts touching the charge
pins. Red LED flashes when charging is activated. Charge the batteries for 16 hours before
initial use.
• Please insert the batteries with the correct polarity.
• Only use the included rechargeable shortened sleeve NiMH batteries with your
headphones. Other types of rechargeable batteries cannot be charged with this system.
• AA Alkaline batteries can be used to operate the headphones, but cannot be charged with
this system.
• Please ensure the headphones are well placed on the transmitter so that the Signal Charger
Indicator flashes red, showing charging is in progress.
• When the batteries are empty, it takes approximately 5 hours to fully charge the batteries.
• When the batteries are fully charged, the headphones can be used for up to 8 hours.
8