Maintenance - Makita XPS01 Instruction Manual

Cordless plunge cut saw
Hide thumbs Also See for XPS01:
Table of Contents

Advertisement

Available languages

Available languages

2
► 1. Front cutting point (165 mm blade) 2. Rear cut-
ting point (165 mm blade)
Guide device
Optional accessory
Use of the bevel guide allows exact miter cuts with
angles and fitting works.
Use of the clamp ensures firm hold of workpiece on the table.

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed before
attempting to perform inspection or maintenance.
CAUTION:
Clean out the guard to ensure
there is no accumulated sawdust which may
impede the operation of the guarding system. A
dirty guarding system may limit the proper operation
which could result in serious personal injury. The
most effective way to accomplish this cleaning is with
compressed air. If the dust is being blown out of
the guard, be sure the proper eye and breathing
protection is used.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Adjusting 0°-cut and 45°-cut
accuracy
NOTICE:
Do not engage the levers for -1° bevel
angle when adjusting 0°-cut accuracy.
NOTICE:
Do not engage the lever for 48° bevel
angle when adjusting 45°-cut accuracy.
These adjustments have been made at the factory. But if they
are off, you can adjust them as the following procedures.
1.
Slightly loosen the clamping screws on the front
and rear of the tool.
2.
Adjust the blade angle.
1
1
► 1. Triangular rule
To adjust the 0°-cut accuracy, make the base perpen-
dicular to the blade using a triangular rule, square rule,
etc. by turning the adjusting bolt.
► 1. Adjusting bolt for 0°-cut
To adjust the 45°-cut accuracy, make the base 45° to
the blade using a triangular rule by turning the adjusting
bolt.
► 1. Adjusting bolt for 45°-cut
3.
Tighten the clamping screws and make a test cut.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
15 ENGLISH
45°
1
1
1

Advertisement

Table of Contents
loading

Table of Contents