Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Alcatel Voyager
Summary of Contents for Alcatel Voyager
- Page 1 Audio out 3.5 PL Expansion port GPS antenna RF antenna Harness cable & Fuses Speaker Microphone Ignition Mute Swivel mount Installation instructions...
-
Page 2: Table Of Contents
Phone Layout ..................3 Preplanned Accessory Positioning ............4 Installing the Swivel mount and Phone..........6 Installing the Microphone..............8 Installing the Speaker ................9 Installing the Electrical Connections ............ 10 Installing the Cellular Antenna ............. 12 Installing the GPS Antenna ..............14 Troubleshooting................... -
Page 3: Phone Layout
Display / Touch Screen Home key Search key Menu key Exit/Back key Send key End key (dialing / answering a call) OK key (Select/OK key) Voice input key Navigation key USIM card Volume up / Volume down Micro SD Mini USB connector USB connector Reset Installation instructions... -
Page 4: Preplanned Accessory Positioning
Positioning of all accessories must be planned in advance before installation begins. Ensure that no wire braids go through locations where Phone accessories are to be installed. Ensure that any parts of the handsfree Phone will not interfere with the vehicle or its accessories’... - Page 5 ’ ’ Install the handsfree Phone’s microphone 30-40 cm away from where the driver speaks when he/she is in their normal driving position. It is recommended to install the microphone on the right side of the sun visor, away from the vehicle’s window and from external sources of noise.
-
Page 6: Installing The Swivel Mount And Phone
Handsfree Phone Swivel mount The best way to determine the Phone’s position to the customer’s full satisfaction is to locate it when the customer is beside you and obtain Note! his/her agreement. Please ensure the Phone’s location does not interfere with the vehicle or its accessories operation: it should not interfere with opening the glove compartment or ashtray, should not prevent access to the lighter, moving the gear stick, operating the hand break etc. - Page 7 Ensure the Phone would be protected from direct sunlight and humidity (air conditioner openings). Ensure the Phone would be protected from mechanical damage by the car’s accessories. 1. Disassemble the swivel mount joint from its two base units. 2.
-
Page 8: Installing The Microphone
The microphone is provided with a clip which makes it possible to install it on the sun visor. Install the handsfree Phone’s microphone 30-40 cm away from where the driver speaks when he/she is in their normal driving position. ... -
Page 9: Installing The Speaker
The speaker and microphone (installed on the sun visor above the driver) must face different directions. Note! If the speaker and microphone face each other, this will cause echo. Do not hide the speaker inside the dash board. If you cover it, sound quality will be lowered. -
Page 10: Installing The Electrical Connections
The electrical cable is provided separately from the control cable. Before installation begins, connect the four leads (which include the 3A fuses) using a red or blue crimp sleeve as appropriate. Please note sharp edges or moving parts which may damage the wires. ... - Page 11 The following chart covers the manner by which the voltage cable should be connected to the car’s electrical system. Wire Color Function Must be Ensure… connected to… To provide the 12V fixed voltage Ensure a 250V / 3A handsfree Phone fuse is used Connect with red with fixed voltage...
-
Page 12: Installing The Cellular Antenna
The preferred location for the antenna is on the right side of the windshield. If a cell phone or other communication system is installed in the car, please locate the antenna as far away as possible from the other Phone’s antenna. ... - Page 13 1. Thoroughly clean the location intended for installation on both sides of window using a cloth and detergent. Allow the spot to dry before you continue. 2. Carefully remove the clear plastic cover protecting the external adapter (the antenna base). 3.
-
Page 14: Installing The Gps Antenna
1. The GPS antenna enables reception of satellite transmissions required for the operation of the navigation application. 2. Attach the GPS antenna to the right side of the windshield, at least 8 cm from the cellular antenna. 3. Remove the antenna's sticker cover and wipe the surface to achieve firm attachment. -
Page 15: Troubleshooting
Symptom What to Check What to Do No reception Check whether connector is correctly Replace connector connected to the cable – use an efficiency meter Check if internal and external antenna Attach antenna base base is correctly attached Check proper working order of Replace antenna cable antenna cable Other party...