Advertisement
DHCP NETWORKS
To know what IP has been assigned to the card by DHCP network, user can run SNMP Manager
software to perform scan. SNMP manager is available as separate software in the CD or it can be run
from Viewpower Pro software (as indicated in software manual).
Install and execute SNMP MANAGER to open interface window as described in the figure:
We suggest to login as administrator in the System section with password: 12345678
FIG 3: SNMP WEB MANAGER:
Introduce password: 12345678
IP address
SCAN
Press SCAN to show all cards with dynamic IP available in the network. This process could take some
minutes. Sometimes this SCAN process must be performed several times, until detecting cards.
Take note of the IP for the card and write it in the address bar in the navigator. You can also simply
double click over IP address listed in the SNMP Manager window. System will open navigator will Web
Pro interface.
_______________________________________________________
SNMP-06 (161212)
SNMP06 LAN CARD
REFERENCE MANUAL
5
STATIC IP NETWORKS
If the network where UPS will be connected is static IP network, the network administrator must assign
an IP to the UPS LAN card. This can be done by following procedure:
1.- UPS with SNMP card must be ON
2.- One PC with SNMP MANAGER or Viewpower Pro must be connected to the SNMP card directly
by a RJ45 cable. There are new SNMP cards that can be detected though the network. For those
cards PC can be connected to the network and try to make contact with the SNMP card.
3.- SNMP MANAGER must detect card automatically. If not, a manual SCAN must be done. This
scan process could take about 2 to 5 minutes. Do some scans if necessary.
4.- Select the IP shown in the left area of the SNMP Manager screen.
5.- Open IP SETTINGS tab and select option: "Use a Static Address".
NOTE: If system does not allow modifications, do SCAN again and repeat previous steps.
6.- Introduce manually static IP address, Subnet mask y Default Gateway.
7.- Select APPLY command key to save modifications.
System could require you a password. In that case introduce password:
APPLY again to save modifications. System must show a message:
"OPERATION SUCCESSFULL"
FIG 4: SNMP WEB MANAGER:
_______________________________________________________
SNMP-06 (161212)
SNMP06 LAN CARD
REFERENCE MANUAL
12345678. Then do
6
Advertisement
