Nissin AIR 10S Instruction Manual page 23

Buzz (Beep sound) on strobes
All settings of strobes are controlled by the commander wirelessly after the pairing
is completed. If the strobes buzzer is on, a "Beep" sound will be heard when the
Strobe is charging and not ready to flash. The "Beep" sound will be heard everytime
when there is any change made through the commander.
Air 10s (Canon ) Beep or Buzzer on & off switch
Hold button to switch the buzzer (on strobes) on or off.
When "no buzzer" logo is displayed in LCD, it means that the beep sound is off.
When the "no buzzer" logo disappears, then the buzzer function is turned on.
CAUTIONS CAUTIONS
User can use the below synchronization cable to connect the Air 10s with camera.
When the shutter release remote function of MG10(strobe) is on, press the shutter
release button on it to trigger the Air 10s. Air 10s will automatically received the
signal. Then the focus and exposure of camera can be control by the connected
synchronization cable.
For Canon EOS 80D, 70D, 77D, 800D,
760D, 750D, 700D, 200D, 100D, 60Da,
60D, 650D,600D, 1300D, 550D, 500D,
500D, 300D, 400D, 350D, 1100D, 1000D
For Canon EOS 1D X Mark II, EOS-1D X,
5Ds/5DsR, 5D Mark IV, 5D Mark III, 6D
Mark II, 6D, 7D Mark II, 7D, EOS-1Ds Mark
III, EOS-1Ds Mark II, EOS-1Ds, EOS-1D
Mark IV, EOS-1D Mark III, EOS-1D Mark II N,
EOS-1D Mark II, EOS-1D, 5D Mark II,
5D,50D, 40D, 30D, 20D, 10D, 60Da
22