Advertisement
TROUBLE SHOOTING
SYMPTOM A: NO AC POWER OUTPUT, THE RED LED LIGHTS.
POSSIBLE CAUSES
The connected AC products are rated at more than 150 Watts
(PINV1) , 300 Watts (PINV2) or 400 Watts (PINV3), the
overload shutdown occurred.
The connected AC products are rated at less than 150 Watts
(PINV1) , 300 Watts (PINV2) or 400 Watts (PINV3), the high
starting surge causes the overload shutdown.
The battery is discharged (alarm sounds)
The inverter overheated
SYMPTOM B: NO AC POWER OUTPUT, NO LED LIGHTS ARE ON.
POSSIBLE CAUSES
The lighter socket or 12 Volt outlet has been poor contacted
The lighter socket or 12 Volt may require ignition to be on.
The fuse of cigarette lighter or 12 Volt outlet is blown
The fuse of inverter is blown
The inverter has been connected with reverse DC input
polarity.
SUGGESTION
Use the product with a total power rating
less than 150 Watts (PINV1) , 300 Watts
(PINV2) and 400 Watts (PINV3) .
Use the product not exceeds the inverter's
surge capacity, 300 Watts (PINV1) , 600
Watts (PINV2) and 800 Watts (PINV3) .
Recharge battery.
Turn off the inverter and allow to cool for 15
minutes. Clear blocked fan (PINV2 / PINV3)
or remove the objects covering the ventilation.
SUGGESTION
Press plug into socket firmly.
Turn key to accessory position.
Check vehicle fuses and replace.
Check to make sure the inverter is
connected to a power source with correct
voltage and polarity.
Replace fuse.
The inverter needs repairment
if the probable damage has occurred.
6
Advertisement
