Installing Indoor Equipment (Niu 6054 Only) - Nortel CTR 38 GHz Installation Manual

Installing Indoor Equipment (NIU 6054 only)

Install the NIU 6054 equipment associated with the CTR 38 GHz microwave
transceiver as follows:
1. Adjust voltage out of NIU 6054. It is adjustable from 17V to 21 V,
2. Connect CTR 38 GHz IF/PS cable to the NIU 6054's output (PS/IF) port
3. Connect CTR 38 GHz RX cable to NIU N-type (bulkhead) connector.
4. Refer to Reunion NIU 6054 Network Interface Unit Installation Guide,
Figure 1-3
Block Diagram showing CTR 38 GHz indoor set-up with NIU 6054
IF OUT/DC Power
NIU
IF IN
depending on cable length and type.
(N-type connector).
Release 1.1, 411- 1323 - 201, and the Network Engineering Package.
CTR 38 GHz Release 1.2 1-13
IF IN/DC Power
IF OUT
Reunion CTR 38 GHz Installation Guide
CTR