Advertisement
Fig. 1-3-8
12. Leave the LCD block until the adhesive is hardened
for a required time. In this case, place a thin paper on
the LCD block to prevent dusts from entering.
13. When the adhesive is hardened, connect the FPC of
the LCD to the connector of the PC board, and turn on
the power. Check to see pixel deviation of the LCD.
14. Check to see dusts of the LCD. If dusts are found,
remove them.
15. Turn the power off. Remove all the cables connected
to the PC board and LCD panel, and remove the drive
PC board.
16. Turn on the power and check operations.
Fig. 1-3-9
Fig. 1-3-10
1-5
Advertisement
