Related Manuals for CHARDER MEDICAL HM80M
Summary of Contents for CHARDER MEDICAL HM80M
- Page 1 HM80M Baby Length Height measurement Please keep the instruction manual at hand all the time for future reference.
-
Page 2: Table Of Contents
TABLE OF CONTENTS PREFACE.....................2 CLEANING....................2 MAINTENANCE..................2 SAFETY INSTRUCTIONS .................2 WARRANTY ....................3 EXPLANATION OF THE GRAPHIC SYMBOLS ........5... -
Page 3: Preface
PREFACE Thank you for choosing CHARDER MEDICAL product. All features of this product were designed to state of the art and are optimized for simple and straightforward use. If you have any queries or experience any problems not addressed in the... -
Page 4: Warranty
Observe operating instructions. Please use no other than the supplied fixtures for mounting. During assembling, ensure that screws are tightened properly and that the height measuring rod has been assembled correctly. To prevent risk of injury, ensure that the head stop is returned to folded-in position after each use. - Page 5 Dimensions (WxHxL): 29 x 7 x 62 cm Weight: 700g Accuracy: ±10mm Temperature range: 5℃ up to 35℃ Medical product in accordance with Directive 2007/47/EC: Class I Items Spec. Qty. HM80M mechanical baby length User manual IN-1576 Bracket set for baby SS-5611 tray(option)
-
Page 6: Explanation Of The Graphic Symbols
EXPLANATION OF THE GRAPHIC SYMBOLS SN-T13000001 Designation of the serial number of every device, applied at the device. (Number as an example) “Please note the accompanying documents“ or “Observe operating instructions” Identification of manufacturer of medical product including address Charder Electronic Co., Ltd. No.103, Guozhong Rd., Dali Dist., Taichung City 412, Taiwan (R.O.C.) Dispose of old appliances... - Page 7 Carefully read this operation manual before setup and commissioning, even if you are already familiar with Charder scales. Transport and storage temperature limit indicating the upper and the +60°C lower limit (Transport and storage temperature -20°C on packaging)
- Page 8 If head stop is loose please re-assemble it as below. HOW TO MEASURE Lay the baby at flat platform. The baby’s head must be at the head stop of HM80M. Gently keep the baby’s knees down onto the platform. Keep the baby still on the platform with left hand.
- Page 9 Using right hand to push the foot stop in the direction of the baby’s feet until foot stop touches the soles of baby’s feet. Read off the length of the baby from the marking on measuring rod. ASSEMBLY WITH REMOVABLE BABY TRAY Bracket for assembly with scale is an optional accessory.
- Page 10 Press the buckle to secure HM80M is welled installed. 3. Assembly completed...
- Page 11 ASSEMBLY WITH MS5900 BABY SCALE 1. Remove bracket holder cover. 2. Take off bracket holder cover.
- Page 12 3. Fixing bracket with two screws. SS-6111 bracket 4. Assemble baby height rod with the bracket carefully until click. FOR HM 80M & HM80D Slide Photo shown above is indicative only.
- Page 13 5. Install the bracket holder cover. HM 80D HM 80M ASSEMBLY WITH MS2400 BABY SCALE Place the bracket and tighten the screw with screw driver. rubber head pad SS-5621 bracket Fix the bracket here for the scale with rubber head pad rubber head pad...
- Page 14 Fix the bracket here for the scale without rubber head pad Assemble baby height rod with the bracket carefully until click.
- Page 15 NOTE...
- Page 16 Manufacturer’s Declaration of Conformity This product has been manufactured in accordance with the harmonized European standards, following the provisions of the below stated directives: 93/42/EEC amended 2007/47/EC Medical Device Directive Please see separate document showing on sticker of device for above CE marking.