Philips HTS3106/F7 C Service Manual page 21

Caution:
• Make sure the FFC cable is inserted in the proper direction so the Pin 1 of COMTOOL jig relay board and Pin 1
of BD MAIN CBA connector is connected.
Location of Pin 1 on BD Main CBA
• If the device driver (CDM 2.06.00 WHQL Certified) of COMTOOL jig relay board is not installed in the PC, install
this before connecting COMTOOL jig relay board to the PC.
<How to install the device driver for COMTOOL jig relay board>
1) Save the device driver for COMTOOL jig relay board in the C: drive.
2) Connect COMTOOL jig relay board to the PC.
3) The driver installation screen opens. Select [Install from a list or specific location (Advanced)] then click
[Next].
4) Select [Search for the best driver in these locations.] then check the box for [Include this location in the
search:].
5) Click on Browse button then select the device driver (CDM 2.06.00 WHQL Certified) folder in the C: drive.
Click [Next].
6) Confirm that installation of [USB Serial Converter] device driver has completed and click on [Finish].
2. How To Check Which Port Is Used For COMTOOL Jig Relay Board
2-1. Click on the Windows [Start] button on the PC.
2-2. Right click on [My Computer].
2-3. Click on [Properties].
2-4. Click on [Hardware] tab in System Properties window.
2-5. Click on [Device Manager].
2-6. Click on [Ports (COM&LPT)].
2-7. Check which connection port is assigned for [USB Serial Port] (e.g. COM1).
The connection port number assigned here will be used later during setup of application.
3. Application Setup
3-1. Save the application folder (OpuDataWriter) directly under the C: drive.
3-2. Create a shortcut for [OpuDataWriter.exe] which is located inside the folder on the desktop.
1pin
Pin 1 is located on the left side
1-8-2 HT3.5(2D)_HT_AIR