Speaker Wiring - Pyle PLCD27 Owner's Manual

Follow this easy wiring diagram in order to enable you to install
the new or existing RADIO and SPEAKER wring system.
Be sure the unit is connected to a 12 volts battery with negative ground.
Good ground connections eliminate most electrical noise problem and
require tight with the metal vehicle chassis. remove plastic, paint or dust
for good electrical contact.
CAR ANTENNA
RED
WHITE
Connect to control for antenna
or remote control for amplifier.
Memory+
Connect to battery or +12 volts of
power source that is always live.
Ground-
12V+
Connect to lgnition key switch.
RCH
RCA line out RCA line out
LCH
Orange
YELLOW
Black
Red
10

SPEAKER WIRING

The unit is only designed for the use with 4 speakers system, it can
only be connected with speakers rated in the load impedance range
from 4 to 8 ohms. Load impedance less than 4 ohms could damage
the unit.
Never combine (BRIDGE) the outputs for use with 2 speakers, and
Never ground any Negative speaker to the chassis ground.
CAR ANTENNA
Green
Green
/white
Right Front
Left Front
Brown
Brown
/white
Left Rear
RED RCH
RCA line out RCA line out
WHITE LCH
Grey
Grey
/white
Blue
Blue
/white
Right Rear