Important Safety Precautions - Chill Solutions CSXC-1 Owner's Manual

Read all instructions.
1.
For indoor use only.
2.
Do not use for other than intended use.
3.
Before the chiller is supplied with power, the water inlet/outlet piping and water circulation system
4.
must be activated and tested. This ensures that the chiller connections are water tight, and the chiller
has sufficient water circulation.
To protect against electrical shock, do not place cord, plugs or the chiller in water or other liquid.
5.
Do not operate this chiller with a damaged cord or plug, or if the chiller malfunctions. Return the unit to
6.
Chill Solutions for inspection, repair or adjustment. See warranty section for further details.
To avoid the possibility of the AC power plug, power supply transformer, or the chiller getting wet,
7.
position the aquarium and the chiller components in such a way to allow a "drip loop" to be formed similar
to the figure shown. This "drip loop" will prevent water from traveling along the power cord and coming
into contact with appliance plug. If the power plug becomes wet, DO NOT unplug the cord.
Disconnect the fuse, or circuit breaker that supplies power to the plug first. Then proceed to unplug the
chiller power cord, and check for the presence of water in the AC power receptacle.
DRIP LOOP
.
If an extension cord is necessary, an extension cord with the proper amperage rating should be incorporated.
8.
An extension cord rated for less amperage, or power than the transformer requires may cause the extension
cord to overheat. The extension cord must be a cord which incorporates a polarized connection arrangement
and has a ground plug.
Do not install in a sealed location. Provide four to six inches of air space around the fan and heat
9.
sink for proper air circulation.
Do not install or store the chiller where it will be exposed to external weather or temperatures below freezing.
10.
Do not attempt to repair this product. Repairs should only be executed by authorized service personnel.
11.
Failure to abide by the above instructions will void the chiller's warranty.
12.
SAFETY PRECAUTIONS
CHILLER
TRANSFORMER/
POWER SUPPLY
TANK
2