Installation - Pyle DISC CD CHANGE Instruction Manual

INSTALLATION

• Use the supplied parts and mount the unit securely. The use of parts other than
these supplied (specified) may loosen or damage internal components.
• If installation presents any difficulties, consult your dealer for advice.
• Before drilling a hole into the wall or floor the vehicle trunk, check that nothing is
behind the panel. Never drill a hole in the fuel tank or any other important that may
be attached to the trunk.
• Take off the negative terminal connector (–) of the car battery to prevent short
circuits while you are installing the unit.
TOP
Location
• Be sure to mount the unit in a location that will not interfere with the driver or
passengers. Be certain there is not danger of passengers being injured case of
sudden stops.
• Do not mount the player near heater outlets, where it might be affected by heat; or
near doors, where rainwater might splash onto it.
• Do not mount the player in a location that will receive direct sunlight, such as on
the dashboard or the rear shell. Excess heat will damage the player.
• When mounting the player make sure no wires are trapped between the player and
the surrounding metalwork or fittings.
• Do not mount the player on the spare lire board or any other unstable place.
• Do not mount the player where it will impede access to the spare tire, jack or tools.
• Although the player can be mounted horizontally, vertically or at 45°, keep to the
tolerable angles shown on following page. In addition, choose a place where the
CD magazine can be loaded and unloaded easily.
Proper
TOP
Improper
FRONT
5
FRONT