Table of Contents
Advertisement
Changing the side on which
the door is hinged
Proceed as follows to change
the side on which the door is hinged:
Set the programme selector to the
1.
"Off" position, disconnect the dryer
from the mains and open the door.
Remove the screws from the dryer
2.
and then remove the dryer door.
Use a T20 (Torx) screwdriver
Note:
only. Do not use any other tools to
change the side on which the door is
hinged.
Installation and connection
Carefully place the dryer door onto a
3.
flat surface, and place a hand towel
or other such item between the door
and the surface to avoid scratching
or damaging the door.
Now remove the screws from the
4.
door hinge, and remove the hinge
from the dryer door.
Remove the screws from the door
5.
handle on the dryer door and
remove the door handle.
en
15
Advertisement
Table of Contents
