Specifications - Audiolab STEEL S13.4 DSP User Manual

Dsp professional power amplifier - 4 x 1670w @ 4-ohm
Table of Contents

Advertisement

Available languages

Available languages

1. OVERVIEW
STEEL S13.4 DSP
DSP Professional power amplifier - 4 x 1670W @
4-ohm
Steel S13.4 DSP is a professional power amplifi-
er with a maximum output power of 4 x 1220W
@ 8-ohm / 4 x 1670W @ 4-ohm and a maximum
bridged output power of 2 x 4000W (RMS) @
8-ohm. With a performance that stands out for
its very low distortion and high fidelity, Steel S13.4
DSP is equipped with a switching-mode power
supply. Precisely thanks to the design of its pow-
er supply, the amplifier allows the peak power to
follow the dynamic range of the musical program,
being able to reproduce up to twice the RMS
power, without clipping. This translates, basically,
into peaks with much more dynamic range than a
conventional-source amplifier. Last but not least,
Steel S13.4 DSP incorporates an advanced DSP
module that allows the user to generate and save
configurations, and send the processed signal to
other amplifiers of the Steel series.

Specifications

Output
Rated output power (8-Ohm): 4 x 1220W
Rated output power (4-Ohm): 4 x 1670W
Rated output power (Bridge @ 8-Ohm): 2 x
4000W
Performance
Input impedance:
- Balanced: 20Kohm
- Unbalanced: 10Kohm
Input sensitivity: 0.775Vor1.4V
Frequency Response: 20Hz~20KHz
P. 2
AUDIOLAB S13.4 DSP -
English version
THD: <0.05%
Damping factor (8-ohms) 10Hz-400Hz: >200
Crosstalk (at 1Khz): - 75dB
Signal to noise ratio: >100dB
Slew rate: 20V/us
Voltage gain: 37.8dB
Intermodulation distortion: =/<0.35%
Protections: Thermal, short circuits, no-load,
on/off muting & RF interference
DSP Processor
Software - Windows® compatible
Input
Channel gain and mute
Input sensitivity selector
Input assignable between 4 channels
Frequency generator selectable to any channel
Signal meters
Departure
Boost per channel
Crossover per channel
10 parametric equalizers per channel
Delay per channel (in milliseconds or
meters)
Limiter per channel
Bridge selector by output
Signal meters
Connectors & back panel controls
Power supply connector: Interlock In
4 XLR-3 inputs
4 Speakon speaker outputs
4 Eurolock outputs
Bridge, parallel & input sensibility switch

Advertisement

Table of Contents
loading

Table of Contents