Advertisement
Assembly Instructions (cont)
Step 3
To set up the Nursery Swing (10) for use, carefully fold the armrest over the backrest and then
Note:
fold the base down. Position the back rest so that it is at a 90 degree angle to the base, then push it
down until it clicks into place. Next align the armrest so that it is at an angle of slightly less than 90
degree to the backrest and push the sides together until they fit into the backrest. Finally place the
2 x Pins (9) into the base of the Nursery Swing (10). Ensure that the seat is aligned properly before
placing the pins into the seat, if the pins are forced into the seat when it hasn't been aligned correctly
it will cause the pins to break.
Should the rope come off the bearing during use, stop using the swing seat immediately and
Note:
place the rope back over the bearing before using the swing seat again.
Attach the Nursery Swing (10) to the Top Bar (6) using 2 x M6x38mm (F6).
The 2 x M6x38mm are pre-assembled to the nursery swing.
Note:
5
8
48
1
3
3
7
5
3
1
You can check
the seat is
aligned as you
will be able to
2
see through
the holes on
the sides of the
seat.
49
2
49
12
14
13
48
3
3
7
5
S002028 Action Nursery Swing
5
Advertisement
