Table of Contents
Advertisement
USER GUIDE
4.0/ Plug & Play procedure
4.1/ Control Unit Initializing
Start the Control Unit (without connecting sensors or with sensors connected but not stuck) without connec-
ting distributors. The left display show nothing and the middle dash blink on the right display (internal dis-
tributor). Press the blue remote control to validate the internal distributor (address 0). If the Control Unit is
started with at least one sensor stuck, it will display the first defective sensor fully or partially unstuck and
you will have then to validate all the defective points from 1 to 8.
After Validation, the left display show " 1 " blinking and nothing on the right display because no distributor
is connected. Press the blue key to validate the missing distributor and then repeat this operation till the
display show the decimal point blinking meaning that the Control Unit is running.
4.2/ Distributors Programming
When the control Unit is running, connect the first virgin distributor (without connecting sensors or with sen-
sors connected but not stuck) whose red LED is alight. The left display show number "1" blinking and the
right display show the middle dash blinking indicating that it will validate automatically this distributor at
the address " 1 " in 30 seconds, in the meantime, one bip will be emitted every 5 seconds. If you agree,
you can speed the procedure validating with the blue remote control and stick label "1" on it then repeat
this operation with all the distributors you have in the limit of 9.
Warning, if the connected distributor has at least one sensor stuck, the Control Unit
will not take care of them and the validation of the Distributor will validate also the
connected sensors
In the Plug & Play procedure, it is not possible to allocate distributors leaving blanks (i.e.: 1, 3, 5, 7, 9) the
addresses proposed by the Control Unit are in order (1,2,3,4,5,6,7,8,9).
When a distributor is operating, the LED blinks briefly every second.
WARNING, you never must connect in the same time several virgin distributors to
the Control Unit because they will get the same address and will generate false
alarms.
5.0/ Maintenance procedure
5.1/ Programming
This procedure allows programming the distributors one by one, which means only one distributor can be
connected to the Control Unit in the same time. If several virgin distributors are connected in the same time
the LED of each distributor which normally must lit continuously will blink randomly.
To enter this procedure, you need to have a Yellow remote control allocated to the Control Unit and stop it
pressing 5 seconds on the blue remote control.
You must wait to be on the right menu and on the right address to connect the distributor.
Press briefly on the yellow remote control and you see number " 1 " on the right, meaning you are at the "
ringing " menu level, press briefly a new time on the yellow remote control and you reach the level of the
cycling power menu, press briefly for the third time on the yellow remote control and you are at the pro-
graming distributor menu. Press 2 seconds the remote control and the left digit display the number " 1 "
blinking and the right digit displays nothing. You have to press as much as necessary to reach the number
you chosen and then connect the distributor (virgin or already programmed) which will get the current ad-
dress stabilizing the display. Sticks the corresponding label and disconnect it, you will see on the left digit
display the following number blinking and, if you do nothing, the control unit exit the programing mode
after 5 seconds.
Update : 7/2/11
0Z NOT FR 0906
Vitrea
page: 8
Hide quick links:
Advertisement
Table of Contents
