Table of Contents
Advertisement
User Instructions
Before first use
Setting up the shredder
1. Remove the Laminator from the packaging
and unwind the cord to its full length.
2. Plug the machine into a suitable power
supply outlet.
3. Make sure the function switch is at "OFF"
position.
4. Connect the plug to the 220-240V AC mains.
Using your appliance
1. Plug the machine into a suitable power supply
outlet.
2. For cold lamination, Switch to Cold
(︳)position to connect the power and start
with cold lamination, the LED will light up Blue,
the power is on and ready for cold lamination;
For hot lamination ,switch to Hot (∥) position,
the LED will light up Blue, the machine will
start to heat up. After 3-5 minutes, the Orange
READY LED will illuminate when the machine
has reached the correct operating temperature.
The machine is ready to laminate.
3. Prepare the laminating pouch for inserting into
the machine. Load the paper centrally into the
pouch alongside the pre-sealed edge. Do not
use pouches thicker than 250micron
(2x125micro per side).
4. When the machine has reached operating
temperature, the pouch can be inserted into
the machine until it engages with the rollers.
Always insert the pouch with the close edge
into the machine. This will have a better finish.
Do not insert the pouch with open edge into
the machine. This may cause jam issue in the
machine.
5. The pouch will move through the machine and
exit at another side.
6. Turn the laminator OFF (O) after use.
7. Remove the plug from the power supply.
6
Advertisement
Table of Contents
