Disassembly For Repair - Kenwood TH-D72A Service Manual

TH-D72A/D72E
Document Copyrights
Copyright 2010 by Kenwood Corporation. All rights re-
served.
No part of this manual may be reproduced, translated,
distributed, or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or other-
wise, for any purpose without the prior written permission
of Kenwood.
1. How to Remove the Case Assembly
from the Chassis
1. Remove 2 screws q.
2. Remove 2 knobs w.
3. Remove the SP/MIC jack cover e.
4. Remove the front panel from the chassis.
2. How to Remove the PCB
2-1. Control PCB (TX-RX A/3)
1. Remove the packing (CHASSIS) r.
2. Remove 1 screw t then lift the SP holder and remove
the FPC y, u.
3. Remove 5 screws i, o and remove the packing (SP/
MIC) !0 .
4. Lift the control PCB and remove the FPC !1 , !2 from TX-
RX PCB.
2-2. RF PCB (TX-RX C/3)
5. Remove the top panel !3 from the chassis.
6. Remove the solder of the earth spring !4 and lift.
Note: After TX-RX PCB is fi xed to the chassis with the
screws, the earth spring is installed.
7. Remove 10 screws !5 , !6 , and 3 round screw !7 .
8. Lift the TX-RX PCB.
2

DISASSEMBLY FOR REPAIR

Disclaimer
While every precaution has been taken in the preparation
of this manual, Kenwood assumes no responsibility for er-
rors or omissions. Neither is any liability assumed for dam-
ages resulting from the use of the information contained
herein. Kenwood reserves the right to make changes to any
products herein at any time for improvement purposes.
(X57-784)
(A/3)
(X57-784)
(C/3)
CN719
(X57-784)
CN715
(A/3)