Alpine Hemlock Owner's Manual
  1. Manuals
  2. Brands
  3. Alpine Manuals
  4. Dryer
  5. Hemlock
  6. Owner's manual
Alpine Hemlock Owner's Manual

Alpine Hemlock Owner's Manual

Hand dryer
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
OWNER'S MANUAL
HEMLOCK
INSTALLATION GUIDE
WARRANTY

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hemlock and is the answer not in the manual?

Questions and answers

Related Manuals for Alpine Hemlock

Summary of Contents for Alpine Hemlock

  • Page 1 OWNER’S MANUAL HEMLOCK INSTALLATION GUIDE WARRANTY...

  • Page 2: Important Safety Instructions

    Failure to do so may result in incorrect operation, damage to property and/or personal injury. Alpine Industries will not be held liable for any damage to property or personal injury, or any loss of business or revenue, if you, your staff, your installer or service engineers have not followed the instructions given in this manual and the installation guide.

  • Page 3: Cleaning & Maintenance

    INSIDE Alpine recommends regularly checking and cleaning the insides of your machine to ensure proper performance. Use a soft dry cloth or brush to gently remove dust from parts and inlet holes. If your unit contains a filter, be sure it does not come in contact with water.
  • Page 4 HEMLOCK INSTALLING THE HAND DRYER UNIT CAUTION: Make sure that no electrical wiring or pipe work are located directly behind area of drilling. 1. If hardwired, disconnect power source of electricity previously bought to the hand dryer location. 2. Be sure there is no obstruction between floor and dryer. If mounted over counter top place dryer no less than 16 inches above counter.

  • Page 5: Limited Warranty

    The parts are warranted for a period of 5 years from the start of the warranty. Wire cord for a period of one year from the start of the warranty. Alpine Industries will provide part replacement for original defects, when used in accordance to the owner’s manual and installation guide.

  • Page 6: Troubleshooting

    TROUBLESHOOTING Dryer does not turn on 1. Check power to the unit and connections. Verify dryer is receiving the correct voltage at the Terminal Block (check dryer label on the outside bottom of the cover). 2. Adjust the sensor range (refer to wiring diagram sheet). 3.
  • Page 7 Black...
  • Page 8 Open cover and take hand dryer from wall Base fix screw Allen key 1. Remove and retain 2 side security hex cover screws by allen key then move the cover. 2. It is recommended to take hand dryer from wall ONLY when replace a new motor or two side cover fix brackets .
  • Page 9 Replace Main circuit board Main Board 1. Disconnect all the wires form the circuit board. 2. Unscrew the 3 screws and remove the main board. 3. Connect new main board. 4. Reconnect all the wires (see Diagram on page 1). Replace LED Lock 1.
  • Page 10 Replace filter or HEPA filter (If supplied) HEPA If it is a normal air filter: Just pull it out as it is soft. Then replace a new one. If it is a HEPA air filter: 1. Remove air inlet right cover by loosening 4 screw(Be sure not to lose them). 2.

Table of Contents