Removing Collected Water - ALDI EDR050BAUW User Manual

Operating
Dehumidifying mode instructions
When the power button is pressed, the power light turns
on and the dehumidifier automatically defaults to:
Display: Current ambient room humidity (RH%)
Humidity Setting: 40% RH
Fan Speed: High
Note: Depending on humidity conditions of the sur-
rounding environment, the dehumidifier may not start
automatically under the default setting. This is an indi-
cation that the humidity level of the surrounding envi-
ronment is lower than the "default" setting of 40% RH.
Therefore, it may be necessary to scroll through each
of the different dehumidifier settings 35%-55% until the
humidity sensor recognizes conditions that will allow the
unit to operate.
Dehumidifying Mode Selection:
The unit enters dehumidify mode when the power button
is pressed.
Press the + / - buttons to select a desired RH operating
value (35%-85%).
OR
Press the continuous button. When continuous mode is
selected, the humidity sensor will be by-passed and the
compressor will operate non-stop regardless of humidity
conditions.
Fan Speed Selection:
You can choose a fan speed (low or high) using the key-
pad. The speed you select is identified by the illuminated
indicator light located directly above the selection made.
Note: For optimal performance, ensure that the unit is
set at least 10% lower than the relative humidity level. It
is normal for the humidity to vary by 5% above or below
the set humidity. It is recommended that in normal condi-
tions, the humidity be set at 40-45%.
14
Removing the collected water
There are two ways to remove collected water:
Use the bucket
When the bucket is full, the compressor turns off and the
fan turns off after drying the water off the condenser for 30
seconds. The unit will beep 8 times and the bucket full indicator
light will flash, and the digital display shows P2.
To empty the bucket, slowly pull out the bucket. Grip the left
and right handles securely, and carefully pull it straight out so
water does not spill. Do not put the tank on the floor because
the bottom of the bucket is uneven. Otherwise the bucket will
fall and cause water to spill. Discard the water and return the
bucket to the unit. The bucket must be placed and properly po-
sitioned for the dehumidifier to operate. The machine will restart
when the bucket is restored in its correct position.
Note: When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product. Be sure
to push the bucket gently all the way into the unit. Banging the
bucket against anything or failing to push it in securely may
cause the unit not to operate. When you remove the bucket, if
there is some water inside the unit you must dry it. The power
button flashes when the bucket is not properly in place.
A1. Pull the bucket out a little
A2. Hold both sides of the bucket with
even strength, and pull it out from the
unit. Pour the water out.
Operating
15