System Requirements - Danfoss AK-SM 800AL User Manual

User Guide | Alarm Logger, AK-SM 800AL
Introduction
The AK-SM 800AL Alarm Logger is designed to complement a
Danfoss System Manager 800 application, where a dedicated
alarm receiver solution is required. The Danfoss AK-SM 800AL has
been designed for simplicity of setup and daily use, taking advan-
tage of a new touch screen user interface.
The AK-SM 800AL is intended to be part of the System Manager
host network, utilizing IP/Ethernet communications between all
units. Alarms raised at any System Manager 800 can be forward-
ed/routed to the alarm logger for action and escalation by store
staff.

System requirements

To ensure correct function and operation, the following system
requirements must be met;
• AK-SM 800AL will only function with System Manager 800 units
• Minimum software requirement for AK-SM 800 units is 08.06x
and above
• Master unit (net address 0) must be available on the host net-
work
• Host SM800 network must be established between AK-SM 800
units and available for AK-SM 800AL
2 | RS8HR102
© Danfoss | ADAP-KOOL® | 2018.01